Home » Tips » How To Create Wi-Fi HotSpot With Command Prompt

How To Create Wi-Fi HotSpot With Command Prompt

IP_Configured-How-To-Create-Wi-Fi-HotSpot-with-Command-Prompt
To create a Wi-Fi hotspot to share your computer internet you can do so through the Command Prompt. To successfully do this, use the Administrator privilege to run the command.
In the Command Prompt enter the following command to enable Wi-Fi Hotspot.

 

Enter  netsh wlan set hostednetwork mode=allow ssid=Hotspotname key=password

 

To start Hotspot

 

Enter   netsh wlan start hostednetwork

 

To stop hotspot

 

Enter netsh wlan stop hostednetwork

 

Sharing this hotspot for everyone to use the internet connection, go to Network and Internet option from Control panel and click on View Network Status and Tasks and then click on Change Adaptor Setting in the left panel.

 

Now right click on the internet connection you are using and click on Properties. Go to Sharing tab and check the option “Allow other network users to connect through this computer’s internet connection” to share your internet connection.

 

Recommended To Read: Networking Command You Should Know

About Alfred Francis Osei

Leave a Reply

Your email address will not be published. Required fields are marked *

*